|
 |
Please
click image to order a catalogue.
|
| Cross
& Morse offer a comprehensive
range of standard stock gears
which, coupled with the capability
to supply on short lead times
custom designed gears, provides
the design engineer with a
wide spectrum of solutions
from which to select open
gear drives. |
Gear
Products
Bevel and Mitre Gear
D.P. Module Bevel and Mitre
Gears
Racks
Spur Gears |
|
Standard Stock Gears
The range of standard stock
gears can be summarised as
follows:
Bevel
and Mitre Gears
Straight Cut Bevel and Mitre
Gears manufactured to the
Modul system in medium carbon
steels enable simple right
angle drives with reduction
ratios up to 4:1. Two series
of gears are offered, the
first the original T.D. Cross
range to imperial dimensions
from 16DP to 5DP pitch, the
second a much improved metric
range of gears from 1 Mod.
to 5 Mod. pitch. All gears
can be induction or flame
hardened for longer life under
arduous conditions.
Spur
Gears
A
new range of 20° PA. spur
gears all manufactured in
medium carbon steel, provide
selection from 1 Mod. through
to 6 Mod. pitch with gears
from 12 teeth to 120 teeth.
Gears have face width equal
to ten times Mod. number to
provide sensible power transmission
capability.
Straight
Racks
Available in standard lengths
of 05, 1.0, 2.0 and 3 metres
is a range of 20° PA straight
cut racks with pitch range
1 Mod. to 8 Mod. These are
designed to combine with the
standard spur gears to provide
low cost conversion of rotary
to linear motion.
|
|
| |
|
|
| |
| Special
Custom Made Gear Products
Modification of standard gears
by reworking the bore and
faces, and adding heat treatment
often provides the most economical
gear solution; but for those
applications where standard
gears cannot be used, special
gears and racks can be manufactured
within the following limits.
|
|
Mitre
and Bevel Gears
Straight
cut gears to the Modul System
up to 250mm diameter,
available in a variety of
materials.
Spur Gears
In diametral
or module pitch available
in most sizes both 14.1/2°
and 20° pressure angle
up to a maximum top diameter
of 56 inches in a variety
of materials.
Helical
Gears
With helix angles up to 45
° maximum O/D of up to 330mm.
With helix angles up to 30
° maximum O/D of over 330mm
to 1420mm.
Top diameter 1420mm, maximum
face width 240mm.
Straight
Racks
Racks in Module or Diametral
(DP) pitch can be supplied
up to a
maximum length of 2 metres
and face width 95mm.
Maximum pitch 12 Mod, 3 D.P.
Minimum pitch 0.5 Mod, 120
D.P.
Internal
Gears and Splines
Available in the range:
Outside diameter Max. 400mm
Bore diameter Max 300mm
Face width Max 95mm.
Splines
and Serrations
Involute, flat root, or fillet
root splines and serrations
can be cut on
machined shafts or customer
blanks.
|
|
|
|
|
|
|
| |
 |
|
